A gravel walkway offers a casual, low-maintenance path through your yard.
Inexpensive and simple to install, gravel walkways present few challenges for
do-it-yourselfers. Once the walkway is installed, its most common problems have
one simple solution. Adding edging to the walkway blocks encroaching grass and
also keeps gravel from scattering into the lawn. Installing edging is a simple
project you can finish in a day.
Instructions as follows:
Firstly, decide on the type of edging material. For a structured look, or
to add definition to the walkway, use natural stones, bricks or pavers.
Secondly, measure the width of the edging material, and mark an equal
distance from the edge of the walkway with a tape measure and garden stakes.
Wind a string around the stakes down the length of both sides of the
walkway.
Thirdly, rake back the gravel from the sides of the walkway. Unearth dirt
and grass within the outlined space with a shovel, and keep digging for 4 inches
if you're edging with paving stones or pavers. Tamp down the dirt at the bottom
with the back of a hoe or a tamper tool.
Fourthly, pour 2 inches of coarse masonry sand along the trench and tamp it
down.
Fifthly, set the bricks or natural stones in the trench side by side, or
set the bricks end to end lengthwise for a narrower border. Place the materials
flush together, leaving as little space as possible between them. Hit each brick
or stone with a hammer to embed it in the bed of sand and make the pieces level
with each other. Continue setting the materials until the trench is filled.
没有评论:
发表评论